Hi all,
I am currently facing an issue when I try to install Win10 April 2018 update (1803) on an iMac 2017 (27 inches, Retina 5K). I did research a bit and reset the NVRAM, but this did not help in solving the issue.
ISSUE:
1, The installer disc could not be found.
- Insert your Windows installer disc and wait a few seconds for the disc to be recognized
![]()
2, After clicking Go Back -> and selecting as below -> Press Continue
![]()
3, It says No USB Drive
![]()
4, I connect a USB Drive, I get this, I press Continue
![]()
5, I now get Boot Camp installation failed
![]()
6, Then it tries to Rollback partition, I close it (as it stays in the same page for 10 mins) and manually remove it using Disk Utility
![]()
7, I then tried again after unmounting the Disk image, as well as formatting the WININSTALL. This leads me again to step 1.
![]()
MACHINE CONFIGURATION:
![]()
I am currently facing an issue when I try to install Win10 April 2018 update (1803) on an iMac 2017 (27 inches, Retina 5K). I did research a bit and reset the NVRAM, but this did not help in solving the issue.
ISSUE:
1, The installer disc could not be found.
- Insert your Windows installer disc and wait a few seconds for the disc to be recognized
2, After clicking Go Back -> and selecting as below -> Press Continue
3, It says No USB Drive
4, I connect a USB Drive, I get this, I press Continue
5, I now get Boot Camp installation failed
6, Then it tries to Rollback partition, I close it (as it stays in the same page for 10 mins) and manually remove it using Disk Utility
7, I then tried again after unmounting the Disk image, as well as formatting the WININSTALL. This leads me again to step 1.
MACHINE CONFIGURATION:
