Hi all,
Please pardon my ignorance, but I do need some help in that I currently have a Mac Pro - Mid 2010 with a NVIDIA Quadro K5000 4096 running two Apple 24" LED Cinema Displays.
Today, I had to move my setup to another room in my house and upon setting things back up, only one display is being detected and even though it's detected, it is only displaying half the resolution (currently it's at 1280 x 720) and I am unable to change it to the displays regular resolution (see screenshot).
A couple of things to note, from both of my displays, I do have mini-display port adaptors going into a female mini-display port with a male display port that plugs into the back of the graphics card. Both displays have these adaptors to work with the graphics card.
As mentioned I am running 10.13.6. Any help would be tremendous, even just to get the one display that is being detected to at least run in it's a better resolution.
I had read somewhere that someone said they had downloaded display drivers. I did a bit of looking into this, but other than the 2012 driver release for the LED Cinema displays, I didn't come across anything in this aspect, but didn't want to chase this path further, if it was just going to lead me down another wormhole.
FWIW, I did do a NVRAM reset earlier, but that didn't trip anything to help remedy the resolution issue.
Thanks in advance for any help or insight.
Please pardon my ignorance, but I do need some help in that I currently have a Mac Pro - Mid 2010 with a NVIDIA Quadro K5000 4096 running two Apple 24" LED Cinema Displays.
Today, I had to move my setup to another room in my house and upon setting things back up, only one display is being detected and even though it's detected, it is only displaying half the resolution (currently it's at 1280 x 720) and I am unable to change it to the displays regular resolution (see screenshot).
A couple of things to note, from both of my displays, I do have mini-display port adaptors going into a female mini-display port with a male display port that plugs into the back of the graphics card. Both displays have these adaptors to work with the graphics card.
As mentioned I am running 10.13.6. Any help would be tremendous, even just to get the one display that is being detected to at least run in it's a better resolution.
I had read somewhere that someone said they had downloaded display drivers. I did a bit of looking into this, but other than the 2012 driver release for the LED Cinema displays, I didn't come across anything in this aspect, but didn't want to chase this path further, if it was just going to lead me down another wormhole.
FWIW, I did do a NVRAM reset earlier, but that didn't trip anything to help remedy the resolution issue.
Thanks in advance for any help or insight.
